Switches the Panformer off, after reaching the programmed length. The last programmed length stays in the counter. Simply press the reset lever once to repeat the same length.
Preselection Counter, with one preset adding mode and switch for operation or non - operation.

To produce panels on top of the roof, the supporting legs can be adjusted to the slope of the roof.

Cuts the panels at the exit, therefore short panels can be manufactured for walls, from the coil without difficulties. The guillotine shear cuts the panel without distortion, burr-free and not damaging the surface of pre-painted or patinated material.
Panformers were the cut for short panels is at the entrance guide, have to be fed into the machine in single operation.

Width adjustment by hand wheel by a scale, exact to the mm.

To produce narrow panels from a wider coil, in one operation without distortion and deforming the material. When disassembled from the panformer, the Metal Shear can be used for hand-cutting.
These are the advantages against stationary cutting-rolls.

For additional rigidity use the adjustable stiffening rolls. The maximum lowest point 1.5 mm, adjusted or disengaged through an eccentric shaft. Possibility to additional ribs, more the two.