K10-FH
|
|
Fixed Clip Former K10-FH
Bending and punching 2 holes, height 25 mm for fixed cleat.
Also available for other panel heights.
Without picture:
Fixed Clip Former K10-FSH
|
|
A hand operated tool to manufacture fixed cleats.
Bending, punches holes, perforates and cuts in one operation. Height 25 mm, width of material 39 mm.
|
K10-HS
|
|
Without picture:
Y-Clip Former K10-LH
|
|
Material 39 mm width, punches holes, bends and cuts off. Measurements 39x35x11 mm for flashings, air intakes, verge and valley panels.
Y-Clip Former K10-HS
Material 39 mm wide, to make Y-shape cleats.
Height 75 mm. Punches holes, bends and cuts material off.
|
K10-FH
|
|
Clip Former Top Part K10-EHS (2 units)
Two hand operated units
a)
|
unit to bend and cut
|
b)
|
to shape contour for bottom part sliding clip. Material 29 mm wide, length variable.
|
|
K10-SHS
|
|
Motorised Clip Former K10-SHS (2 units)
a)
|
A motor powered unit (K10-ESH) 230 volt for fast production of sliding clip bottom part. approx. 15 clips/min. Cuts length, slits and punches holes. Top clip fits into bottom part.
|
b)
|
Hand-operated tool bends bottom part to an angle of 90º and is mounted next to the clipformer.
|
|
